Anyone uses TRD exhaust manifold header?

Any problems with your Altezza, post questions here
petreunited
Noob!
Posts: 6
Joined: Mon Dec 22, 2014 6:32 pm

Anyone uses TRD exhaust manifold header?

Postby petreunited » Sun Apr 17, 2016 3:53 pm

Hi,

installed TRD exhaust manifold header and had two problems.

1. O2 sensor is too hard to reach the hole, its too short, can i extend it?
2. TRD header can be attached only to the engine and doesnt have extra hangers like stock one(stock header is attached to gearbox with extra hanger). i got some vibration voices after installing.

Protok
Tezza Fanatic!
Posts: 372
Joined: Sun Aug 15, 2010 8:56 pm

Re: Anyone uses TRD exhaust manifold header?

Postby Protok » Sun Apr 17, 2016 10:14 pm

Sounds like you have fitted a manual manifold to an automatic.

Extending the O2 sensor is fine, just make sure you solder and shield the wiring properly.

petreunited
Noob!
Posts: 6
Joined: Mon Dec 22, 2014 6:32 pm

Re: Anyone uses TRD exhaust manifold header?

Postby petreunited » Thu Apr 21, 2016 7:42 pm

No of course, i fitted to my mt, header part no - 17141-SE110. its a bit surprising to me that it hangs only on engine until cat.

petreunited
Noob!
Posts: 6
Joined: Mon Dec 22, 2014 6:32 pm

Re: Anyone uses TRD exhaust manifold header?

Postby petreunited » Thu Apr 21, 2016 7:43 pm

Protok wrote:Sounds like you have fitted a manual manifold to an automatic.

Extending the O2 sensor is fine, just make sure you solder and shield the wiring properly.



No of course, i fitted to my mt, header part no - 17141-SE110. its a bit surprising to me that it hangs only on engine until cat.


Return to “Problems with your Altezza”

Who is online

Users browsing this forum: No registered users and 0 guests