3/8 drive socket and 10mm socket
3/8 drive extension
1/4 drive socket and 10mm socket
I find it easier to remove all the under panel screws first, it will give you more play in the plastic in the wheel well and make it easier to pull the bumper around it when that time comes. All the bolts at 10mm around the bottom.
Remove the front two plastic push rivets from each side with a flathead screwdriver. Just pop the head out and the rest will will come out too with a little force of the flathead
Pop the plastic out form behind the bumper and pull it back a little. It will take a little force to pop it out around the top, but it will come out, just pull.
Unscrew the top bolt on the inside of the plastic. As you do this, you will begin to see the bumper drop down at the corners just under the headlight. This is also a 10mm socket, just find it and unscrew it.
Remove the 4 plastic screws on the outside of the grill and the screw in the center of the grill. You don't have to take the grill completely off, the bumper will still drop with the tabs attached
Start pulling on the bumper until you have it off all the way around and then drop it down to the ground. I always lay a towel out so that the bumper doesn't set directly on the ground
This step will be different for most other people since i have HID fogs, but you can just unplug the connector from the fog light bulb (depending on the length of your wire you may have to reach behind the bumper before you pull it off to do this so you have enough room to set it on the ground)Your bumper is now off the car. Now on to the headlight removal.
Unbolt the screw on the top of the headlight. 10mm screw
you have to get inside the wheel well to see these two bolts on the back of the headlight. They are a pain in the ass to get, the bottom one can be gotten with the 3/8 drive socket, but the top one is easier to get with a 1/4 drive, especially if you have big hands like me. They are both 10mm
You will have to wiggle the headlight out as far as it will go and then pull it up and out. If you do it right, it will sound like you broke something, like two piece of plastic were snapped apart. See the video to hear this and see how to pull it out
If you need to take the headlight all the way out, just pull the connectors off all of the bulbs and any thing else that needs to be unplugged and pull it out. Hope this helps anyone out and if you have any questions, PM me of post them up.