Timing belt breakage HELP

[ronansxe10]

So I was diffing and I was on the rev limiter for a long time and car just knocked off and belt was shredded. Put a new belt on to see if valves were bent and engine wouldn't start no compression. So I know valves are bent anyone this experience before? Just want to know extent of what damage could be done eg valves pistons etc.. Reply please thanks!

[Noel]

Hi,

Happened to me years back

I'm afraid you need to start looking for a replacement engine, I spent more repairing mine than a secondhand would have cost and it took ages between ordering all the parts and my mechanic finding enough time to work on it...

Even after it was all fixed properly, a few months later another part broke internally and it was f*** again...

Hard luck

[tais300]

i hate to agree, but id look for a new engine as well. valves can be pricey, and machine work can be pricey too. figure $300 minimum on valves, (replace them all, i know from experience lol) a new timing belt kit with tensioners and idlers $250-300 and since your in there a new waterpump would be a best investment as well so add another $200. oh and if you have my luck lift the head and see the oil pan through a piston....... well you know the answer to that madness. pull the head and check damage, if you have the time to do it. that will be your decision maker

[ronansxe10]

Hi,

Happened to me years back

I'm afraid you need to start looking for a replacement engine, I spent more repairing mine than a secondhand would have cost and it took ages between ordering all the parts and my mechanic finding enough time to work on it...

Even after it was all fixed properly, a few months later another part broke internally and it was f*** again...

Hard luck

Ya that's true I would be sending the head off to be done but thing is a good engine if very hard to get these days at least I know my valves with be perfect and so will my head am I right? If pistons are would it not be better to know what you have up top with new parts? :/

[ronansxe10]

Ok head is off and the only damage is the chaise valves are bent. Does anybody know where I can get them?

[tommysheen]

If your valves are bent chances are you damaged the piston and bent the rods too. You'll have to strip it fully and get someone that knows engines so have a look
Engines can be got at jdmdistro or elite autos €900 is the going rate

[Celica RA45]

only the valves will be bent you wont have damaged the rods ,slight nick in the pistons ,will be about all/i also have low kilometre valves in ti for sale .400 aussie with postage to you includes paypal as well ,these valves are out of low 16,000 kay motors

[tommysheen]

What part of the world are ya in as well that might help

[Celica RA45]

tommy sheen 400 aussie might mean im from australia sorry

[ronansxe10]

The pistons and rods are sound it's just the 8 exhaust valves that bent. Head is going away for new valves and to get skimmed and pressure tested. Just checking where I can get valves incase they can't get them. I'm from ireland

[tommysheen]

Good out what part. I'm in cork and have a set of valves if your stuck

[ronansxe10]

Mayo tommy. How much for set of exhaust valves. 8 of them