ImageGreetings! Welcome to Tezzaworld website, unfortunately you are a few years late to the show as nearly everyone has been and gone, there is still lots of useful archived material to read through, not many active users unfortunately, but that’s the way it goes, hopefully you are not too disappointed...

Anyone uses TRD exhaust manifold header?

Any problems with your Altezza, post questions here
petreunited
Noob!
Posts: 6
Joined: Mon Dec 22, 2014 6:32 pm

Anyone uses TRD exhaust manifold header?

Postby petreunited » Sun Apr 17, 2016 3:53 pm

Hi,

installed TRD exhaust manifold header and had two problems.

1. O2 sensor is too hard to reach the hole, its too short, can i extend it?
2. TRD header can be attached only to the engine and doesnt have extra hangers like stock one(stock header is attached to gearbox with extra hanger). i got some vibration voices after installing.

Protok
Tezza Fanatic!
Posts: 372
Joined: Sun Aug 15, 2010 8:56 pm

Re: Anyone uses TRD exhaust manifold header?

Postby Protok » Sun Apr 17, 2016 10:14 pm

Sounds like you have fitted a manual manifold to an automatic.

Extending the O2 sensor is fine, just make sure you solder and shield the wiring properly.

petreunited
Noob!
Posts: 6
Joined: Mon Dec 22, 2014 6:32 pm

Re: Anyone uses TRD exhaust manifold header?

Postby petreunited » Thu Apr 21, 2016 7:42 pm

No of course, i fitted to my mt, header part no - 17141-SE110. its a bit surprising to me that it hangs only on engine until cat.

petreunited
Noob!
Posts: 6
Joined: Mon Dec 22, 2014 6:32 pm

Re: Anyone uses TRD exhaust manifold header?

Postby petreunited » Thu Apr 21, 2016 7:43 pm

Protok wrote:Sounds like you have fitted a manual manifold to an automatic.

Extending the O2 sensor is fine, just make sure you solder and shield the wiring properly.



No of course, i fitted to my mt, header part no - 17141-SE110. its a bit surprising to me that it hangs only on engine until cat.


Return to “Problems with your Altezza”

Who is online

Users browsing this forum: No registered users and 0 guests