Altezza dyno

[ESXTEZZ]

http://img838.imageshack.us/img838/2903/bwp5.jpg

This was with the old engine a while back, it's all I have on my phone

[donut46]

Mother of jayus that is a hell of an impressive figure!!!

[Soiled]

http://img838.imageshack.us/img838/2903/bwp5.jpg

This was with the old engine a while back, it's all I have on my phone

That looks very tidy!

[tomo]

Awesome soiled, what rods, pistons etc you running? The gearbox holding up alright at that power then?

[Soiled]

Toda pistons, eagle 3sgte rods. The gearbox is doing fine. I'm sure it will give out eventually this one has had a whine since I put it in.

[mike_01]

wow cheers, do you loose power from the charge cooler being on or is it negligible? I used to have a celica carlos sainz with charge cooler set up as standard but was on a 2" pipework but the cooler only came on under boost or over half pedal pressed could only just touch the unit as it was really cold when it had a cycle but normally was boiling hot not far off the water tank but people didn't recommend running them constantly and a lot change to a fmic set up

[tomo]

Toda pistons, eagle 3sgte rods. The gearbox is doing fine. I'm sure it will give out eventually this one has had a whine since I put it in.

What compression ratio are you running?

[Soiled]

8.5:1

[turbotezza]

im impressed buddy and hopefully soon be hot on your tail,,i almost had you dude!
what ecu ya got ,,thanks for reply in my head help thread ,,what cams n springs you got too ,,,not that im gona copy you ,,,much!

[Soiled]

PowerFC, Toda cams (as mentioned in the other thread) and Toda valve springs.

Copy away