Page 1 of 1

Clutch plate question

Posted: Thu Mar 10, 2016 10:30 pm
by dogger
I have the TRD 3 puck clutch and I'm wanting to get it refaced. I've found a place that will do it, but he wants to know how thick it should be. Anyone have any ideas? All my googling has got me nowhere.
Is it too much to assume it would be the same thickness as a standard clutch??

Re: Clutch plate question

Posted: Tue Mar 15, 2016 11:11 am
by RS Tom-Hundred
Not sure on this but wonder if Nick would know or if there is info on the NZ forum as I think they still sell them over there :)

Re: Clutch plate question

Posted: Wed Mar 16, 2016 6:25 pm
by turbotezza
if its any help i brought a new trd clutch which im just about to put in my rebuld ,,i could measure it with a vernier gauge for you