ImageGreetings! Welcome to Tezzaworld website, unfortunately you are a few years late to the show as nearly everyone has been and gone, there is still lots of useful archived material to read through, not many active users unfortunately, but that’s the way it goes, hopefully you are not too disappointed...

2.5 stroker using 5sfe block?

Post info/questions on engine mods and issues here
oaasport
Trc On!
Posts: 59
Joined: Sun Apr 26, 2015 2:25 pm

2.5 stroker using 5sfe block?

Postby oaasport » Fri Aug 07, 2015 12:47 am

Aimed for celicara45, but does anybody know about using the 5sfe block with a beams head? I have a machinist who is competent in drilling the oil and water passages to match the beams head. Im assuming external oil lines to control vvti. Also im having a custom oil pan and sump for drain back and oil feed. Since a custom sump and pan will be used, i dont believe it will need to be dry sump unless somebody can tell me it wont flow or drain right for a transverse fwd engine block mated to a rwd head. Using celicara45 stroker 2.4 and itbs amd good cams im assuming 280-300hp on pump 93* (equivalent to 98ron) can be made?

Return to “Engine & Transmission section”

Who is online

Users browsing this forum: No registered users and 1 guest