ImageGreetings! Welcome to Tezzaworld website, unfortunately you are a few years late to the show as nearly everyone has been and gone, there is still lots of useful archived material to read through, not many active users unfortunately, but that’s the way it goes, hopefully you are not too disappointed...

Maf wiring z32

Post info/questions on engine mods and issues here
Trd Shane
Tezza Fanatic!
Posts: 232
Joined: Mon Dec 02, 2013 10:44 pm
Location: Dublin

Maf wiring z32

Postby Trd Shane » Thu Jul 23, 2015 10:10 pm

Has anybody on here wired a z32 Nissan mad into the Tezza ..
I need wiring help .. Or has anybody the wiring for the Toyota maf I have the pin outs for the Nissan one

Need it for the car to be mapped on sat all help would be great
"If it can't be fixed with a hammer it's an electrical problem"

Altezza Guru
Posts: 705
Joined: Sat Dec 11, 2010 3:35 pm

Re: Maf wiring z32

Postby Soiled » Fri Jul 24, 2015 3:28 am

Can't remember the wiring off the top of my head... But I hope you know the z32 maf doesn't have an integrated temp sensor like the Altezza one. I ran a generic Nissan temp sensor too, welded in just before the throttle body.

I personally believe I made a mistake going to this maf sensor as I now use map for on boost anyway so the factory would have been fine for the off boost readings.

If you needed a slight increase a Subaru sti (think v5) one is a straight replacement.

Return to “Engine & Transmission section”

Who is online

Users browsing this forum: No registered users and 1 guest