ImageGreetings! Welcome to Tezzaworld website, unfortunately you are a few years late to the show as nearly everyone has been and gone, there is still lots of useful archived material to read through, not many active users unfortunately, but that’s the way it goes, hopefully you are not too disappointed...

Going to get the ball rolling on my turbo Project!!

Post info/questions on engine mods and issues here
Vanter
Noob!
Posts: 24
Joined: Sat Mar 30, 2013 7:54 pm

Going to get the ball rolling on my turbo Project!!

Postby Vanter » Thu Aug 01, 2013 12:34 pm

Ok so i'll be on now asking you altezza turbo kings loads of questions as im in the stage of assembling the parts for my turbo build.. My first question is in regards to rods and pistons... Ofcourse im looking at running more than 10pounds of boost so i wanna know if forged pistons and rods made for the 3sgte with the 68mm bore, same as the altezza's would fitted and perform with no problem..
Here are a few examples of what i mean
http://www.ebay.com/itm/CP-Forged-Pisto ... fb&vxp=mtr

http://www.ebay.com/itm/CP-Pistons-Manl ... 3734wt_917

User avatar
tomo
Altezza Guru
Posts: 1127
Joined: Fri Jul 17, 2009 3:10 pm
Location: Poole, Dorset

Re: Going to get the ball rolling on my turbo Project!!

Postby tomo » Thu Aug 01, 2013 6:17 pm

Rods are fine but small end needs machining slightly if being used with standard altezza pistons. I beleive the pistons will fit but won't be any good for turbo application, not %100 but I think cp can do them tho. If you email nick the site trader he was doing a really good deal on forged rods and altezza specific piston sets, was something like 1400nzd I think which works out a similar proce to the ones in link.
Image

User avatar
tomo
Altezza Guru
Posts: 1127
Joined: Fri Jul 17, 2009 3:10 pm
Location: Poole, Dorset

Re: Going to get the ball rolling on my turbo Project!!

Postby tomo » Thu Aug 01, 2013 6:19 pm

http://tezzaworld.com/viewtopic.php?f=40&t=11794
There you go, make sure you email him not pm as he doesn't come on here often.
Image

User avatar
peter0991
Altezza Guru
Posts: 580
Joined: Wed Jun 22, 2011 10:29 am
Location: Aberdeen, Scotland

Re: Going to get the ball rolling on my turbo Project!!

Postby peter0991 » Fri Aug 02, 2013 12:33 am

There is a lot of useful info here as well mate, if you havent had a lookie yet

http://z4.invisionfree.com/lexusaltezza ... topic=7121
Image


Return to “Engine & Transmission section”

Who is online

Users browsing this forum: No registered users and 1 guest