Page 1 of 1

3S-GE-Beams Blacktop forged low comp block

Posted: Mon May 08, 2017 8:49 am
by JZZ30
Good day folks.

Due to a change of plans I am am skipping on forced induction looking to swap my forged beams black top block for a standard block.
The only reason is that I now want to compete in a national touring car series where non stock forced induction is prohibited.

My block as available for a swap:

Precision bored out to 86.5mm
Honed to 0.1mm cylinder to wall clearance
deck skimmed
Main Bearings - ACL Race Bearings
Thrust Bearings - ACL Race Bearings
Lower connection Rod Bearings - ACL Race Bearings

Eagle forged connecting rods (from 3S-GTE)

Wiseco 86.5mm forged pistons from 2JZ-GTE machined to fit oil squirters and larger 3S-GE valves and diff. valve angle.

Can also supply a 1.8mm Apexi metal cylinder head gasket.

Final comp. will be at approx. 9.6:1 (standard head gasket) or 8.4:1 (with the 1.8mm Apexi head gasket)

Build block totaled at about £1'400

Looking for a clean low mileage standard block (complete assembly - crankshaft, rods, pistons) as partial exchange.

Price £800 (+£140 for Apexi head gasket)


Cash sale.

Price £1'100 (+£140 for Apexi head gasket)

Would also consider an aftermarket exhaust header (HKS, Toda or similar) as par ex.

I could also supply a used Greddy cast manifold, a freshly balanced Garrett GT2871RS turbocharger, new 850ccm Injectors and 3" pipe and silencers to build a full 3" exhaust with vband clamps (downpipe already tig welded).

If you are interested please don't hesitate to contact me for questions or further details

Re: 3S-GE-Beams Blacktop forged low comp block

Posted: Thu May 11, 2017 5:19 pm
by JZZ30
Would also remove custom pistons and eagle connecting rods and sell separately:

4 Pcs. 86.5mm custom milled 2JZ-gte Wiseco piston incl. pin and Piston Rings for 0.10mm wall clearance
They will fit stock or 3s-gte connecting rods

Price £380

Set of eagle 3s-gte forged H-beam connecting rods to fit stock or forged 3S-ge pistons or the above

Price £300

Apexi metal head gasket 1.8mm to reduce compression (to 9.6:1 with stock internals or 8.4:1 with the setup above).

Price £130

Re: 3S-GE-Beams Blacktop forged low comp block

Posted: Sat May 20, 2017 4:53 pm
by JZZ30
Pics to be found in my Driftworks for sale thread: ... ck.255693/

Re: 3S-GE-Beams Blacktop forged low comp block

Posted: Fri Aug 11, 2017 6:26 pm
This still available?? Sent you a pm