Page 1 of 1

Anyone uses TRD exhaust manifold header?

Posted: Sun Apr 17, 2016 3:53 pm
by petreunited
Hi,

installed TRD exhaust manifold header and had two problems.

1. O2 sensor is too hard to reach the hole, its too short, can i extend it?
2. TRD header can be attached only to the engine and doesnt have extra hangers like stock one(stock header is attached to gearbox with extra hanger). i got some vibration voices after installing.

Re: Anyone uses TRD exhaust manifold header?

Posted: Sun Apr 17, 2016 10:14 pm
by Protok
Sounds like you have fitted a manual manifold to an automatic.

Extending the O2 sensor is fine, just make sure you solder and shield the wiring properly.

Re: Anyone uses TRD exhaust manifold header?

Posted: Thu Apr 21, 2016 7:42 pm
by petreunited
No of course, i fitted to my mt, header part no - 17141-SE110. its a bit surprising to me that it hangs only on engine until cat.

Re: Anyone uses TRD exhaust manifold header?

Posted: Thu Apr 21, 2016 7:43 pm
by petreunited
Protok wrote:Sounds like you have fitted a manual manifold to an automatic.

Extending the O2 sensor is fine, just make sure you solder and shield the wiring properly.



No of course, i fitted to my mt, header part no - 17141-SE110. its a bit surprising to me that it hangs only on engine until cat.