Fitted Vibratech engine mounts after noticing a vibration on idle.
Turned out the passenger side was in two pieces, so instead of replacing with standard I bought aftermarket.
Now the vibration is near constant, not just idle, worse when making slow maneuvers. One odd thing is it dies down at 3800 rpm, but either side its loud.
I assumed fitting these stiffer mounts would make some vibration, but this seems far too much. As with the originals the vibration disappeared after setting off (just rocked slightly when changing gear due to the broken mount).
My two theories are that I did not tighten correctly, or a stiffer gearbox mount is also needed?
Thanks in advance,