Page 1 of 1
Posted: Mon May 28, 2012 9:53 pm
hi all any 1tell me if i can sort out little bubbles of paint with out respraying tanxs
Posted: Mon May 28, 2012 10:05 pm
You talking about "fisheyes" any pics?
Is it in the paint or clear coat?
Posted: Mon May 28, 2012 10:10 pm
Yes fish eyes it's in the paint their like litre bubbles of air I tried pressing on 1 and it caused a little hair line crack
Posted: Mon May 28, 2012 10:14 pm
They are caused, (I know you didn't ask but this is what I was told)
The surface not been cleaned of polish correct, or prepped right.
Its normally silicone in the cleaner that hasn't been removed.
Did you do it yourself?
Posted: Mon May 28, 2012 10:25 pm
Is it to do with waxing the car
Posted: Tue May 29, 2012 4:54 pm
mirco blister's, caused by a part previously resprayed and done when cold and or bad or no moisture trap in air line, or when weather is damp and left to dry in the damp, they apper when weather is cold and swell when weather get's hot, when waxing probally just shown them up and highlighted them, could pluck them out to make like a stone chip then fill in with some paint, but depends how many you got, if there is some I'll garantee you'll end up with more and more, there almost almost contagious
only way then is to strip paint to bare steel and start again