Landoman wrote:It is for sure the ABS sensor? mine started doing this last week. any info regarding this would be highly appreciated. also where is the ABS sensor located???
griderjn wrote:in your engine bay there is a diagnostic port.
using a paper clip or conductive wire jump E1 to Tc.
turn on ignition (but do not start car)
four indicator lights you need to pay attention to:
3. check engine
each light should continuously blink on and off.
if not, count the numbers.
each fault code will be two digit: first digit, short pause, second digit, then long pause.
there may be several fault codes per indicator.
when you get those numbers,
post them up here.
also, you can reset the ABS computer while in this diagnostic mode by depressing the brake pedal as fast as you can as many times as you can (8 times in 3 seconds i think).
i would check the codes first, then reset the computer, drive around a little bit (take the jumper out), and recheck the codes.
Users browsing this forum: No registered users and 1 guest