Front strut brace

[Dan]

Anyone have front strut brace fitted to the car? if so is simply a case of taking off both ends, securing them to the top of each coilover, the stick in the centre bar and tighten?? Jack the car up or leave it as is?

[Noel]

I'd jack the car alittle to take the pressure off the suspension springs but if you jack it too much then the top part may fall down when you take off the nuts...

[Tez]

its a piece of piss your strut wont fall off

[Dan]

its a piece of piss your strut wont fall off

so i should jack the car up a bit?

[Dizz]

Don't think your supposed to jack up the car because your wheels then camber in when there's no weight on them. Then when you put the strut brace on & lower the car it's stuck cambered out...

Open to correction as always

[Tez]

ye he's right just put it on and tightin it up as hard as possible

[endapender]

Some say not tp jack it up at all cause when its sitting on the ground its at a zero point and flexes in when driving so once its on and tightened up should be enough

[lee_iceman]

Just undo the three nuts either side, fit the brace then do them back up.

Go, get on with it you girl

[Dan]

only problem was getting the right side bracket on, you had to manoveur it around a power steering pipe

[Mr. Tezza]

Damn they're actually a eally nice strut brace a the end of the day, was lookin at those styles ones before but never actually went and bought one, where did ya get urs from? wud you reccomend those strut braces?

[Dan]

got it from Couture Auto but took about 6 weeks to get in though only fitted it yesterday so havent really driven with it on much yet. ill let yous know how i get on with it

[Gerbo]

What make is it? And how much?

[Dan]

Cusco and 190 Euro