Page 2 of 2

Re: Altezza dyno

Posted: Fri Aug 09, 2013 2:12 pm
by ESXTEZZ
http://img838.imageshack.us/img838/2903/bwp5.jpg

This was with the old engine a while back, it's all I have on my phone

Re: Altezza dyno

Posted: Fri Aug 09, 2013 5:50 pm
by donut46
Mother of jayus that is a hell of an impressive figure!!!

Re: Altezza dyno

Posted: Fri Aug 09, 2013 10:49 pm
by Soiled
ESXTEZZ wrote:http://img838.imageshack.us/img838/2903/bwp5.jpg

This was with the old engine a while back, it's all I have on my phone



That looks very tidy! :D

Re: Altezza dyno

Posted: Sat Aug 10, 2013 1:19 pm
by tomo
Awesome soiled, what rods, pistons etc you running? The gearbox holding up alright at that power then?

Re: Altezza dyno

Posted: Sat Aug 10, 2013 11:36 pm
by Soiled
Toda pistons, eagle 3sgte rods. The gearbox is doing fine. I'm sure it will give out eventually this one has had a whine since I put it in.

Re: Altezza dyno

Posted: Sun Aug 11, 2013 11:48 am
by mike_01
wow cheers, do you loose power from the charge cooler being on or is it negligible? I used to have a celica carlos sainz with charge cooler set up as standard but was on a 2" pipework but the cooler only came on under boost or over half pedal pressed could only just touch the unit as it was really cold when it had a cycle but normally was boiling hot not far off the water tank but people didn't recommend running them constantly and a lot change to a fmic set up

Re: Altezza dyno

Posted: Sun Aug 11, 2013 3:01 pm
by tomo
Soiled wrote:Toda pistons, eagle 3sgte rods. The gearbox is doing fine. I'm sure it will give out eventually this one has had a whine since I put it in.


What compression ratio are you running?

Re: Altezza dyno

Posted: Sun Aug 11, 2013 5:56 pm
by Soiled
8.5:1

Re: Altezza dyno

Posted: Wed Nov 04, 2015 12:06 am
by turbotezza
im impressed buddy and hopefully soon be hot on your tail,,i almost had you dude!
what ecu ya got ,,thanks for reply in my head help thread ,,what cams n springs you got too ,,,not that im gona copy you :D ,,,much!

Re: Altezza dyno

Posted: Wed Nov 04, 2015 8:03 am
by Soiled
PowerFC, Toda cams (as mentioned in the other thread) and Toda valve springs.

Copy away :)