Page 1 of 1

Fitting rear tail light covers?

Posted: Fri Jan 25, 2013 11:55 am
by BMcD
Just picked a set of fiberglass rear light covers. Going to get them sprayed, just wondering whats the best way of fitting them? Haven't a clue what to be using for it?

Re: Fitting rear tail light covers?

Posted: Fri Jan 25, 2013 12:24 pm
by punkyy8
You can use tec7 that will work a treat

Re: Fitting rear tail light covers?

Posted: Fri Jan 25, 2013 12:29 pm
by murphman07
I used very thin double sided tape around the edges and they have never budged, been on with about 14 months now.

Re: Fitting rear tail light covers?

Posted: Fri Jan 25, 2013 3:18 pm
by jdmatt89
as said tec7 is the best stuff to use, ive my front splitter held on with it and it hasnt moved an inch and i drive 140+ miles everyday

Re: Fitting rear tail light covers?

Posted: Sat Jan 26, 2013 7:49 pm
by BMcD
Thanks lads, i'll give the tec7 a go. Think theres some knocking about at home.

Re: Fitting rear tail light covers?

Posted: Sun Jan 27, 2013 9:35 am
by mike_01
weather proof clear silicone sealer, and it can be removed, tech7 you can't :wink:

Re: Fitting rear tail light covers?

Posted: Mon Mar 04, 2013 3:55 am
by SilTezza
im using thin 3m double sided and it fits perfect, you can remove it anytime..

Re: Fitting rear tail light covers?

Posted: Mon Mar 04, 2013 3:53 pm
by beamsteza
murphman07 wrote:I used very thin double sided tape around the edges and they have never budged, been on with about 14 months now.


x2 best way incase ya want to remove them again

Re: Fitting rear tail light covers?

Posted: Sat Aug 17, 2013 8:21 pm
by Kirbymeister
I also fitted mine with double sides 3m tape. Same stuff you fit number plates with. Also if you want to take them off gain it won't damage anything either.

Re: Fitting rear tail light covers?

Posted: Sun Aug 18, 2013 12:40 pm
by mike_01
bit of an old post now to resurect :roll:

Re: Fitting rear tail light covers?

Posted: Sun Aug 18, 2013 2:54 pm
by Kirbymeister
I know but i only just fitted my covers the other week and saw this post.

Re: Fitting rear tail light covers?

Posted: Sun Aug 18, 2013 6:02 pm
by beamsteza
murphman07 wrote:I used very thin double sided tape around the edges and they have never budged, been on with about 14 months now.


x2 thats what i always used plus saves the light when ya want to remove again.