ImageGreetings! Welcome to Tezzaworld website, unfortunately you are a few years late to the show as nearly everyone has been and gone, there is still lots of useful archived material to read through, not many active users unfortunately, but that’s the way it goes, hopefully you are not too disappointed...

Dial insert

For all your audio/visual & general interior needs, post here
User avatar
Trc On!
Posts: 31
Joined: Wed Jun 01, 2011 12:18 am
Location: Hull, UK

Dial insert

Postby caltezza » Tue Nov 15, 2011 7:56 pm

Has anyone got any pics of them removing the altezza dial cluster and putting an insert in the centre dial? I have a template ready for it but i don't want to disturb the needles and throw the calibration out


User avatar
Altezza Guru
Posts: 1768
Joined: Mon Feb 07, 2011 12:32 pm
Location: Llanidloes

Re: Dial insert

Postby mike_01 » Tue Dec 13, 2011 7:58 pm

Didn't know they did them for the altezza's just had to learn the conversion from km to mph :lol:
most of them or should I say the more expensive one's like lockwood ones have split's in them to allow you to install them without removing the needle also some I've seen have a bigger hole or something so you work them along and down the needle into place withoug removing hth :wink:

User avatar
Altezza Guru
Posts: 1587
Joined: Sun Aug 03, 2008 4:47 am
Location: New Zealand

Re: Dial insert

Postby E910 » Tue Dec 13, 2011 9:04 pm

The guys on Altezza clubs custom made their own,

Directions for fitting
The needle pulls directly off, yes. BUT when replacing, do not push needle on too hard, the needle should naturally return to zero no matter where you have it, if you push too hard (like I found out) the needle will stick and you won't be able to tell what speed you are doing accurately.



User avatar
Posts: 15
Joined: Thu Jan 13, 2011 12:33 pm
Location: KL,Malaysia

Re: Dial insert

Postby mokh » Sun Dec 18, 2011 1:29 pm

wow..this is cool.
can share the template?

Altezza Guru
Posts: 705
Joined: Sat Dec 11, 2010 3:35 pm

Re: Dial insert

Postby Soiled » Sat Dec 24, 2011 10:24 pm

mokh wrote:wow..this is cool.
can share the template?

I'd say he wouldn't want to share his template, but he done them cheap. So if there was enough interest you could get ask him to make some more. (I got 2 for NZ$30)

And then again you could always just measure up the size of your own cluster and make a design and get a company to make them up for you/do a group buy for this club.

Return to “I.C.E & Interior section”

Who is online

Users browsing this forum: No registered users and 1 guest